Turntable Mode - Noxon 360 Turntable Manual De Usuario

English
Turntable mode: It has 2 main functionalities: photo-by-photo mode (shot by shot) and continuous
video mode.
Movement can be captured in 2 ways:
1.Setting the degrees (angle), so that 90º will be a quarter turn, 180º half a turn, 360º a full turn, 720º
two turns and so on.
2.Inside the REC field establishing the starting point (set start) and end point (set finish).
Allows you to select the number of shots (shots) and the interval between one and the other (inter-
val).
The continuous video mode also allows you to select the speed of rotation of the table.
Settings
• Brightness: Adjusts the screen brightness on a scale of 1 to 10.
• Delay Start: This is the amount of time that elapses between the press to start the programmed
movement and the actual start of the movement. It is configurable in steps of 5 seconds with a range
between 0 (canceling the delay) and 60 seconds.
• Remote Auto-Off: Activates the remote's auto-off after 10 minutes of inactivity.
• Controller Auto-Off: Activates the Compact Slider motion system auto-off after 10 minutes of inacti-
vity.
• LCD Auto-Off: Auto turn off the screen after 60 seconds of inactivity.
• Beep: Activates the playback of a beep just before the start of an automatic movement.
• RF Channel (Radio frequency channel selection): selecting a different channel allows the possibility
of working with two different devices in the same place.
• Info: Allows access to the screen where information about the firmware version of the controller, the
motion system and the serial number is displayed. It also enables activation of the firmware update
mode.
Pág. 12