Start-Up - Noxon 360 Turntable Manual De Usuario

Start up
English
Turning on the Turntable:
1. Connect the battery to the power input of the electronic box.
2. Press and hold the power button until you hear two short beeps.
Table setup:
1. Pull the motor in the fixed frame
2. Adjust the rotation ring using the bearings and the motor.
3. Set the table using the centering devices.
Starting the controller:
1. Press and hold the center button until the screen turns on.
2. Rotate the center knob in any direction to complete the line on the screen.
Synchronization:
1. Synchronization between the 360 Turntable and the hand control is automatic.
2. Once turned on, the appearance of the EXT battery level indicator bar will mean that the connec-
tion between the controller and the turntable has already been established.
NOTE: If the EXT battery indicator (1) we see a rectangle with a diagonal line inside it, it means that
there is no connection.
Charging the wireless controller:
1. Connect USB cable to the controller and to a USB charging port.
Maintenance:
1
1. Keep the bearings where the ring rests clean.
Tips and Warnings:
1. You can leave the charger / power supply connected to the batteries without posing any risk or
deterioration of the battery due to overcharging.
2. Do not pull the motor more than it should when removing and mounting the ring.
3. If the Turntable is not used for a long time, remove the rotating ring to avoid deformations in the
rubber of the traction wheel.
Disclaimer:
Noxon is not responsible for damages caused by improper use or modifications made to the product.
Pág. 9