Fit The Bark Control Collar - Petsafe PBC19-11043 Manual De Funcionamiento

Fit the Bark Control Collar

Important: The proper fi t and placement of your Bark Control Collar is important for
effective operation.
To assure a proper fi t, please follow these steps:
1. Make sure that the Bark Control Collar is turned off.
2. Start with your dog standing comfortably.
3. Place the Bark Control Collar high on your dog's neck close to the
ears. Center the Sensor Probe underneath your dog's neck, touching
the skin. Make sure the PetSafe
upright. Note: It is sometimes necessary to trim the hair around the Sensor
Probe to make sure that contact is consistent.
®
4. The PetSafe QuickFit™ Collar is designed so you can
quickly attach and remove the Bark Control Collar from
your dog while maintaining the desired fi t.
a. With the Snap Buckle fastened, thread the collar through
the Metal Buckle.
b. Slide the excess collar through the "C" Loop on top of
the Snap Buckle.
This will hold the
collar in place.
c. Once the collar
fi t is determined,
simply use the Snap
Buckle to remove
and replace
the collar.
5. The Bark Control
Collar should fi t
snugly, yet loose
enough to allow one fi nger to fi t under the strap. Allow your dog to wear the collar for several
minutes, then re check the fi t. Check the fi t again as your dog becomes more comfortable with
the Bark Control Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar with a pen. Allow for growth if your dog is young or
grows a thick winter coat.
b. Remove the Bark Control Collar from your dog and cut off excess.
Important: The Bark Control Collar should not be worn for more than 8 hours out of
every 24-hour period.
logo in the front of the unit is
®
www.petsafe.net
YES
NO
5