Blower Safety Warnings - Ryobi OBL1820H Traducción De Las Instrucciones Originales

Damaged extension cords should not be repaired, they
should be replaced with an equivalent type.
Make sure the power cord is positioned so that it will not
be stepped on, tripped over or otherwise subjected to
damage or stress.
Never pick up or carry the product by the electric cable.
Never pull by the power cord to disconnect from the
power supply.
Keep the power cord away from heat, oil and sharp
edges.
Always direct the cable to the rear away from the
product.
Make sure voltage is correct for your product. A
nameplate on the product indicates the unit's voltage.
Never connect the product to an AC voltage that differs
from this voltage.
Make sure the switch is in OFF position before
disconnecting from power supply or remove battery
pack.
OPERATION
If the cord becomes damaged during use, disconnect
the cord from the power supply immediately. Do not
touch the cord before disconnecting the power
supply. Do not use the product if the cord is damaged
or worn.
Operate the product only at reasonable hours – not
early in the morning or late at night when people might
be disturbed.
Never operate the product in an explosive atmosphere.
Avoid using the product in bad weather conditions
especially when there is a risk of lightning.
Do not operate in poor lighting. The operator requires a
clear view of the work area to identify potential hazards.
Use of hearing protection reduces the ability to hear
warnings (shouts or alarms). The operator must pay
extra attention to what is going on in the working area.
Do not get distracted and always concentrate on what
you are doing. Think about and consider the effect of
your actions carefully.
Operating similar tools nearby increases both the risk
of hearing injury and the potential for other persons to
enter your working area.
Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance.
Always be sure of the footing on slopes and walk, never
run.
Keep all parts of your body away from any moving part.
Rotating impeller blades can cause severe injury.
Never run the product without the proper equipment
attached. When used as a blower, always install the
blower tubes.
Do not modify the product in any way or use parts
and accessories which are not recommended by the
manufacturer.
WARNING
If the product is dropped, suffers heavy impact or begins
to vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replaced by
an authorised service centre.
To reduce the risk of injury associated with contacting
rotating parts, always stop the product, disconnect from
the mains or remove the battery, and make sure all
moving parts have come to a stop:
before cleaning or clearing a blockage
when leaving the product unattended
before installing or removing attachments
before checking, maintenance or working on the
product
after striking a foreign object to inspect the product
for damage
if the product starts to vibrate abnormally (inspect
immediately)
WARNING
Your blower may be supplied with a harness. Carefully
adjust the harness to comfortably help to support the
weight of the product.
Identify the quick release mechanism and practice using
it before you start using the product. Its correct use may
prevent serious injury in the case of an emergency. Never
wear additional clothing over the harness or otherwise
restrict access to the quick release mechanism.

BLOWER SAFETY WARNINGS

Wear a face filter mask in dusty conditions to reduce
the risk of injury associated with the inhalation of dust.
Do not point the blower nozzle in the direction of people
or pets.
Never place objects inside the blower tubes.
Do not operate the product near open windows, etc.
Slightly dampen surfaces in dusty conditions.
Use the full blower nozzle extension so the air stream
can work close to the ground.
Do not place blower on top of or near loose debris.
Debris may be sucked into intake vent resulting in
possible damage to the product.
ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERY
PACKS
Read, understand and always follow the safety
instructions which came with your battery and charger.
Failure to do so may result in electric shock, fire or other
hazardous situations. Keep all the instructions together
in a safe place for future reference.
Battery operated product do not have to be plugged
into an electrical outlet; therefore, they are always in
operating condition. Remove the disabling device
whenever you are not operating the product.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
English | 3