Hollywood Racks SR1 Manual Del Usuario página 2

1. If the Spare tire on your vehicle is side mounted, go to instruction step 7
2. Place the rear brace around the spare tire (loosen adjustment bolts if necessary), then snug the
adjustment bolts up using the wrench. Do not over-tighten!
3. Wrap the side strap around the bottom of the tire as shown in fig. 1 & 2 and attach to side buckle.
4. Thread the two rear straps around the back of the tire and attach to the two rear buckles located on the
bottom of the main frame.
5. Tighten all three straps and buckles securely
6. Push up on the spring loaded bicycle support arm. Rotate the arms outward . Arms should drop into slot
in a locked position when carrying the bikes, and remain in a folded position when not in use.
7. Side Mounted Spare Tires: Locate the two bolts connecting the support bar to the main frame. Using
the attached hex key and adjustable wrench, loosen and remove the bolts from the rack. Re-position
support bar either left or right depending on your vehicle. Re-insert the bolts through the main frame and
support bar and tighten nuts securely. Return to step 1.
Fig. 3: Bike Cradle
.
Mounting Bikes to the rack:
With the support arms in the outward locked
position, mount the first bicycle into the bike
cradles and pull the strap snugly over the frame.
The handlebars should be on the passenger's side
of the car. Rotate the bike's pedal arm so the
pedal will not be in contact with the car's body or
tire. Be sure the wheels are at least 12"/30cm
from the exhaust pipe, and that the wheels can
clear a steep driveway. Mount the second bike
into the cradles and secure with rubber strap.
Handlebars should be on the driver's side of the
car. Use the included safety/tie down strap to
secure the bike(s) to the rack by wrapping the
strap through the bike's frame and through the
rack.
Fig. 2
Fig. 4: Wrap rubber straps under cables
2