Operation - Black Max BM801700 Manual Del Operador

WARNING:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Never direct a water stream toward people or pets, or
any electrical device. Failure to follow these instructions
could result in serious injury, electric shock, or death.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please call customer service or contact an
authorized service center for assistance.
APPLICATIONS
You may use this tool around the house for cleaning most
small to large horizontal or vertical exterior surfaces, smaller
exterior objects and structures, and outdoor equipment and
tools.* You can:
 Clean or remove mold and mildew from weathered decks,
driveways, patios, walkways, sidewalks, etc.
 Remove dirt from various exterior vertical surfaces such
as house exteriors, siding, fences, brick, concrete or stone
walls, etc.
 Wash boats, outdoor furniture, powered or non-powered
garden equipment, gutters, window screens, grills, play-
ground equipment, etc.
*Always test in an inconspicuous area first.
All manuals and user guides at all-guides.com

OPERATION

PUMP LUBRICANT
The pressure washer pump has been filled with sufficient
lubricant at the factory and is maintenance free. You do not
need to check or add lubricant to the pump before initial use.
STARTING AND STOPPING THE PRESSURE
WASHER
See Figure 12.
 Connect the garden hose.
 Turn the garden hose on then squeeze the high pressure
 After ensuring the switch is in the OFF position, connect
 Press the reset button on the pressure washer's plug to
 Press ON ( I ) on the switch to start the motor.
Page 12 — English
NOTICE:
Do not run the pressure washer without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water flow to the
pressure washer.
NOTE: Make sure the pressure washer's water intake
screen is in place and unclogged before connecting.
trigger to relieve air pressure. Once a steady stream of
water appears, release the trigger.
NOTE: Make sure the faucet is turned on fully and that
there are no kinks or leaks in the hose.
the pressure washer to the power supply.
NOTE: If using an extension cord, make sure to arrange
a drip loop as described on page 3.
WARNING:
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch plug with wet hands.
make sure the unit is ready for operation.
NOTICE:
Routinely make a visual inspection of the pump during
use. If you notice any lubricant leaking around the pump,
stop using the pressure washer immediately and take it
to an authorized service center for repair. Failure to do
so may cause property damage.