Black Max BM801700 Guia De Inicio Rapido

WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to
the operator's manual.
FIRST TIME ASSEMBLY
Connect the high pressure hose to the trigger
1 Install the wheels (see page 10). 5
handle (see page 10).
2 Install the handle (see page 10).
Connect the high pressure hose to the pump (see
6
page 11).
Install the trigger handle storage bracket/nozzle
3
storage panel (see page 10).
Connect your garden hose to the pressure washer
7
(see page 11).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Install the spray wand (see page 10).
4
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
BM801700 QUICK REFERENCE GUIDE
STARTING THE UNIT
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 12).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 3 and 8).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length
100 ft.
NOTE: A.W.G. = American Wire Gauge
2 Press switch ON to start the motor (see page 12).
3
When finished, press switch OFF to stop the motor (see page 12).
SWITCH
OFF
Pour pressure washer
1
detergent in soap tank (see
page 14).
Wire Size (A.W.G.)
25 ft. 14
50 ft. 12
Not Allowed
Use the chart below to determine the correct nozzle for your job.
Concrete, Brick, Masonry
SWITCH
ON Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Always add Pump Protector to the unit after each use and before storing. This will significantly
1
improve pump life. (See page 15.)
Pump Protector is available from your local retailer. For further assistance, call customer service at
1-800-726-5760.
To add, follow the instructions provided by the Pump Protector manufacturer.
Make the most of your purchase! Go to www.blackmaxtools.com
and register your new tool online. For questions about operating
or maintaining your product, please call 1-800-726-5760.
USING DETERGENT
Install blue or black soap Squeeze trigger and wait
2 3
nozzle (see page 14). approx. 5 seconds for
detergent (see page 14).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
NOZZLE SELECTION GUIDE
HIGH PRESSURE
(NO DETERGENT WHEN USING
THESE NOZZLES)
Turbo Nozzle 15º
 



 Recommended Nozzle
Use With Caution for Certain Applications

BEFORE STORING THE UNIT
R
5 S
LOW
PRESSURE
(FOR DETERGENT
OR GENTLE RINSE)
Blue Soap Nozzle




PUMP
PROTECTOR
991000339
1-15-15 (REV:01)