Hisense RS695N4IS1 Manual De Funcionamiento Del Usuario página 10

Second, fully insert the water lines
into the Inlet and Outlet of the water
filter.
Water line
Water Filter
Inlet
insert the 2 clips in the proper
Third,
position as the figure shown below,
and confirm that each clip holds the
water line firmly.
FLOW
Water line
Connecting the filter inlet line to
the water supplier
The connector and the check valve is
provided as one part. You should use
the new connector incidentally but not
the old one you have.
Screw the adaptor onto a suitable 3/4"
BSP connector water outlet, and use
the spanner to tighten it. Fully insert
the water line into the check valve.
Then insert the clip in the install pack
as the figure shown below.
Water valve
Connector
Check valve
Water line
Outlet
Clip
Water line
Spanner
Clip
Filter inlet line
Note:
After installed the filter, please open
the water valve to flush the filter for 5
minutes before use.
Water
The initial dark discoloration of
water is normal.
The water lines must be connected
potable water only.
with the
To operate properly, the ice maker
requires a water pressure of 207~689
Kpa.
Connect filter outlet line to the fridge
The outlet line of the water filter
should be connected with the inlet line
of the refrigerator by a Two-Way
Connector.
The water lines must be fully inserted
into the center of the connector to
prevent water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then
confirm that each clip holds the line
firmly.
Water line
Connector
Clip
Water line
10