Manual del operario
Seguridad general
Señales de seguridad y ubicaciones
114389
DANGER
28236
WARNING
Read and understand Operator's
Manual, Responsibilities Manual and
Safety Manual and all safety signs
before using or maintaining machine.
If you do not understand the
Improper operation or
information in the manuals, consult
maintenance can result in
your supervisor, the owner or the
serious injury or death.
manufacturer.
114416
DANGER
Platform uphill:
Stop all movement.
1Lower boom.
2Retract boom.
Tip-over Hazard
If tilt-alarm
sounds, unit is
on a severe
•Read operator's
slope. Death or
manual before
Platform downhill:
serious injury
attempting to move
1Retract boom.
will result.
machine.
2Lower boom.
114416 A
6
1000262
97579
28236 D
Tip-over Hazard
Welder power supply
reduces rated platform
capacity and
must be factored into total
platform load.
82410
WARNING
Bodily Injury
Failure to use panel cradles according to instructions and safety rules
Hazard
below and in operator's and responsibilities manual could result in death
or serious injury.
Do not exceed rated platform
Weight of panel cradles and load
Do not cause a horizontal force
capacity.Combined weight
in panel cradles may limit
or side load to machine by
of cradles, panels,
maximum number of occupants
raising or lowering a fixed or
occupants, tools and any
in platform to one person.
overhanging load.
other equipment must not
Secure cradles to platform.
Maximum vertical height of
exceed rated capacity.
Secure panel(s) to platform
panels: 4 ft / 1.2 m
Panel cradle assembly
railing using straps provided.
Maximum wind speed:
weighs 30 lbs / 13.6 kg.
Do not operate unless you are
15 mph / 6.7 m/sec
Maximum capacity of panel
adequately instructed and are
Maximum panel area:
cradles is 250 lbs / 113 kg.
aware of all hazards associated
2
32 sq. ft / 3 m
with lifting panels.
S-80 • S-85
Sexta edición • Segunda impresión
DANGER
Tip-over Hazard
Failure to match rated loads could result in an
overloaded platform, which could result in
machine tipping over.
When replacing platform, be
sure rated load on replacement
platform matches rated load on
machine serial number label.
Do not attach this platform to a
machine with any other rated
load.
1000262 B
DANGER
Do not overload
platform.
Welder power supply
weighs 75 lbs / 34 kg.
97579 D
82862
DANGER
114416
97875
97579
114389
100026 2
28236
82862
97875
WARNING
Electrocution Hazard
Component Damage
Failure to properly connect
Hazard
and use the weld line to
Failure to properly
platform could result in death
connect weld leads
or serious injury.
may result in machine
or component
Read, understand and obey all
damage.
warnings and instructions
provided with welding power unit.
Turn welding power unit
off before connecting
Turn welding power unit off
leads.
before connecting leads.
Connect leads to twist-
Be sure weld cables are properly
lock connectors at
connected.
turntable and platform.
DC weld only: 40V, 300 amp
97875 A
maximum.
72875
WARNING
Bodily Injury Hazard
Failure to use pipe cradle assembly according to instructions and safety rules
below and in operator's and responsibilities manual could result in death or
serious injury.
Do not exceed rated platform capacity.
Secure load to platform.
Pipe cradle assembly and weight in pipe
Do not obstruct entrance/exit of platform.
cradles will reduce rated platform capacity
Do not obstruct ability to operate platform
and must be factored into total platform
controls or red Emergency Stop button.
load.
Do not operate unless you are adequately
Pipe cradle assembly weighs 21 lbs /
instructed and are aware of all hazards
9.5 kg.
associated with movement of platform
Maximum capacity of pipe cradle assembly
with overhanging load.
is 200 lbs / 91 kg.
Do not cause a horizontal force or side
Weight of pipe cradle assembly and load in
load to machine by raising or lowering a
pipe cradles may limit maximum number of
fixed or overhanging load.
occupants in platform.
Electrocution Hazard: Keep pipes away
Center load within perimeter of platform.
from all energized electrical conductors.
N.º de pieza 133070SP