ATD -7430 Instrucciones De Funcionamiento Y Manual De Piezas página 4

PREPARATION
Venting trapped air procedure
1. Lower saddle to fully lowered position.
2. Unscrew upper set screw shown at right, (3 mm). Do not fully remove, loosen
only enough for air to escape.
3. While screw is loose, pump jack slowly, forcing trapped air past set screw.
Continue pumping until oil begins to exit vent hole.
4. Tighten vent set screw.
5. Pump to maximum saddle height, pump pedal should not continue to pump
with ease when max height is reached.
6. While lowering saddle, re-release vent screw checking for oil to exit, not air.
7. Tighten vent screw.
8. If problems persist, repeat steps until all air is vented.
OPERATION
Follow the instruction for removal and installation of transmission, transfer case or
transaxle in accordance with the vehicle manufacturer's service manual.
Raising saddle:
Pump foot pedal or press air pump pedal
provided chains.
NOTICE:
WARNING:
!
! WARNING:
Lowering saddle:
WARNING: Clear all tools and personnel before lowering load. Engage release valve pedal slowly. Maintain
!
control of load at all times.
Apply downward pressure to the release valve pedal slowly and carefully.
MAINTENANCE
NOTICE:
Changing oil
NOTICE:
(cont.)
until saddle reaches desired position. Secure load with
4