Safety Considerations - NexD XD800/8V2 Manual Del Propietário

!
IMPORTANT
Mounting the amplifier upside down is
strongly discouraged.
If mounting the amplifier under a seat,
make sure there is at least 1 inch (2.5 cm) of
space above the amplifier's outer shell to permit
proper cooling.

Safety Considerations:

Your amplifier needs to be installed in a dry,
well-ventilated environment and in a manner
which does not interfere with your vehicle's safety
equipment (air bags, seat belt systems, ABS brake
systems, etc.). You should also take the time to
securely mount the amplifier so that it does not
come loose in the event of a collision or a sudden
jolt to the vehicle.
Remote
Input Level Mode
Voltage Switch
(pg. 7) (pg. 9)
Turn-On
Mode
(pg. 6)
Remote
Turn-On
Level
Mode
Mode
Rem. | O set | Signal
Input Voltage
Low | High
(L)
CH. 1 CH. 3 CH. 5 CH. 7
(R)
CH. 2 CH. 4 CH. 6 CH. 8
hannels 1 & 2 Channels 5 & 6
mp Input Jacks Preamp Input Jacks
(pg. 7) (pg. 7)
Channels 3 & 4 Channels 7 & 8
Preamp Input Jacks Preamp Input Jacks
(pg. 7) (pg. 7)
CH. 1&2 CH. 3&4 CH. 5&6 CH. 7&8
INPUT SECTION
Input
Ch. 1 & 2 Ch. 1 & 2 Filter
Mode Status
Filter Mode
Switch LED
Selection
(pg. 7) (pg. 11)
(pg. 8)
Ch. 1 & 2 Input
Sensitivity Control
(pg. 8)
CH. 1 & 2
Input
Sens.
All | 5- 8 | 7&8
Input Mode Filter Mode
2 Ch. | 4 Ch. | 8 Ch. O | HP | LP
Filter Freq. (Hz)
CH. 1 CH. 2
(L) (R)
Jack for
Remote Level
Control Knob
(pg. 9)
Channels 1 & 2
Speaker Outputs
(pg. 10)
Remote
Level
Control
CH. 1 CH. 2
(L) (R)
Bridged
Stupid Mistakes to Avoid
• Check before drilling any holes in your vehicle
to make sure that you will not be drilling
through a gas tank, brake line, wiring harness or
other vital vehicle system.
• Do not run system wiring outside or underneath
the vehicle. This is an extremely dangerous
practice which can result in severe damage to
your vehicle and person.
• Protect all system wires from sharp metal
edges and wear by carefully routing them,
tying them down and using grommets and
loom where appropriate.
• Do not mount the amplifier in the engine
compartment, under the vehicle, on the roof
or in any other area that will expose the
amplifier circuitry to the elements.
Ch. 3 & 4 Ch. 3 & 4 Filter
Frequency Filter Mode Frequency
Selector Selection Selector
(pg. 8) (pg. 8) (pg. 8)
Ch. 3 & 4 Input
Sensitivity Control
(pg. 8)
CH. 3 & 4
Input
Sens.
Filter Mode
O | HP | LP
Filter Freq. (Hz)
CH. 3 CH. 4
(L) (R)
Channels 3 & 4
Speaker Outputs
(pg. 10)
CH. 3 CH. 4
(L) (R)
Bridged
Ch. 5 & 6 Ch. 5 & 6 Filter Ch. 7 & 8
Filter Mode Frequency Filter Mode
Selection Selector Selection
(pg. 8) (pg. 8) (pg. 8)
Ch. 5 & 6 Input
Sensitivity Control
(pg. 8)
CH. 5 & 6 CH. 7 & 8
Input
Sens.
Filter Mode Filter Mode
O | HP | LP O | HP | LP
Filter Freq. (Hz)
CH. 5 CH. 6 CH. 7
(L) (R) (L)
Channels 5 & 6 Channels 7 & 8
Speaker Outputs Speaker Outputs
(pg. 10)
CH. 5 CH. 6 CH. 7
(L) (R) (L)
Bridged
Ch. 7 & 8 Filter
Frequency
Selector
(pg. 8)
Ch. 7 & 8 Input
Sensitivity Control
(pg. 7)
Input
Sens.
Filter Freq. (Hz)
CH. 8
(R)
(pg. 10)
CH. 8
(R)
Bridged
3