Black+Decker BPWM09W Manual De Instrucciones página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING & WARRANTY
SYMPTOMS
Water leaks
Poor stain
removal
Washer will not
drain water
POSSIBLE CAUSE
Over sudsing of
detergent.
Previously set stains.
Kinked drain hose. Drain
located higher than 48
in. above the floor.
SOLUTIONS
Over sudsing may create leaks, and
may be caused by the type and
amount of detergent used. High-
Efficiency detergent is the only
detergent recommended. Make sure
that detergent and any additives
are put into the correct dispenser
compartments. The normal amount
of detergent to use is 1/4 to ½ of the
maximum amount recommended by
the detergent manufacturer. Always
reduce the amount of detergent if
the load is small or lightly soiled, or
if your water bis very soft. Never use
more than the maximum amount
recommended by the detergent
manufacturer.
Articles that have previously been
washed may have stains that have
been set . These stains may be
difficult to remove and may require
hand washing or pre-treating to aid
in stain removal.
Ensure that the drain hose is not
kinked. Make sure that the drain
hose is no higher than 4 ft. above the
bottom of the washer and is no more
than 5 ft. away from the washer.
Page 29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido