Black+Decker BPWM09W Manual De Instrucciones página 31

TROUBLESHOOTING & WARRANTY
SYMPTOMS
Washer not
filling properly
Water leaks
every load
POSSIBLE CAUSE
Filter clogged.
Inlet hoses may be
kinked Insufficient water
supply.
The washer lid is open.
Hot and cold inlet hoses
are reversed.
Water level is too low.
Water inlet valve
damaged.
Hoses not installed
correctly.
SOLUTIONS
Disassemble the water inlet hose and
clean the inlet point. Check that inlet
hoses are not kinked or clogged.
Make sure that both hot and cold
water faucets are turned on all the
way.
The washer will not operate if the
lid is open. Close the lid and make
sure that nothing is caught under
the lid preventing it from closing
completely. Check inlet hose
connections. Make sure the hot
water supply is connected to the
hot inlet valve, and the cold water
supply is connected to the cold inlet
valve.
This is a high efficiency washer. The
water will not normally cover the
clothes.
The fill level is optimized for the
wash motion to achieve the best
wash performance.
Call to the service center for service.
Check all fill and drain hose
connections to ensure that they are
tight and secure.
Page 31