FCC Radio Frequency
Interference (RFI) Statement
for 120V Models
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the
receiver.
•
Plug the unit into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/television
technician for help.
It is the responsibility of the user to obtain the required shielded
cable in order to ensure compliance of this equipment with FCC
regulations.
Changes or modifications not expressly approved by Oki Data
may void your authority to operate this device.
FCC RFI Statement for
230/240-Volt Models
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial
environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
It is the responsibility of the user to obtain the required shielded
cable in order to ensure compliance of this equipment with FCC
regulations.
Changes or modifications not expressly approved by Oki Data
may void your authority to operate this device.
English
4