CAB DIL Manual De Instrucciones página 11

REMOTE LEARNING
If at least a transmitter is stored in the memory of the control panel, it is possible to store new transmitters
without acting on the S2 key. With this storage mode, the new transmitters will get the same functions
of the already stored one.
To store a transmitter using the remote learning, it is sufficient to be close to the built in receiver of
the control unit and proceed as follows:
1. Press the button of the new transmitter to be stored for at least 5 seconds, then release it.
2. Press 3 times the button of the previously stored transmitter (holding down the button for at least
1 sec each time).
3. Press once the button of the new transmitter (holding down the button for at least 1 sec).
4. At this point the new transmitter will be stored in memory with the same functions of the previously
stored transmitter.
To store additional transmitters using the remote learning, repeat the operation from step 1.
TO CLEAR THE MEMORY
Using the procedures outlined below, you can operate two types of memory reset:
1) RADIO MEMORY RESET:
Proceed as follows to cancel all the transmitters from the memory:
1. Hold down the S2 key.
2. The RADIO LED will switch on with fixed light (hold down the button) and then it will start to flash
slowly.
3. Release the button at the third flash.
4. The RADIO LED blinks rapidly until the operation is completed.
5.When the radio memory is empty the RADIO LED will emit 5 flashes.
2) TOTAL RESET:
Proceed as follows to bring the control panel back to factory settings (all the previously stored
transmitters will be deleted and the working time will be reset to 120s)
1. Hold down the S2 key.
2. The RADIO LED will switch on with fixed light (hold down the button) and then it will start to flash
slowly.
3. Release the button at the 5th flash.
4. The RADIO LED flashes rapidly until the operation is completed.
5. When the radio memory is empty the RADIO LED will emit 5 flashes.
DISPOSAL
The item shall be disposed according to regulations in force on waste disposal and recycling of the
various components (metal, plastics, electrical wires, etc.). For this purpose, it is advisable to contact
your installer or a specialised company.
11