The First Wash Cycle; Technical Data; Electrical Connections - SCHOLTES SDLE 129 Manual De Instrucciones

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washer dryer. If this is not the case, replace the
socket or the plug.
! The washer dryer must not be installed ou-
tdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer dryer has been installed, the
electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle

Technical data

Model SDLE 129
width 59,5 cm
Dimensions height 81,5 cm
depth 54,5 cm
from 1 to 7 kg for the wash
programme
Capacity
from 1 to 5 kg for the drying
programme
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05
nections
MPa (0.5 bar)
drum capacity 52 litres
up to 1200 rotations per
Spin speed
minute
Wash: programme
temperature 60°C (1st press
of the button); using a load of
7 kg.
Energy ra-
Drying: the smaller load
ted
must be dried by selecting
programmes
the "IRON DRY" dryness le-
vel. The load must consist of
according to
2 sheets, 1 pillowcase and 1
regulation
hand towel;
EN 50229
the remainder of the load
must be dried by selecting
the "CUPBOARD DRY" dry-
ness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electromagne-
tic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
GB
.
;
3