Important Safety Instructions; English - Newa CASCATA advance 2300 Manual Del Usuario

IMPORTANT SAFETY INSTRUCTIONS

This appliance is a completely underwater pump for
freshwater ornamental outdoor ponds. Any other use
is prohibited and, consequently, not covered by the
manufacturer's liability.
These CASCATA adv pumps are in compliance with
European Standard EN 60335-2-41.
Warning: Strictly adhere to the following warnings in
order to prevent any type of accident: you should also
observe basic safety provisions.
1) CAUTION: This appliance can be
used by children aged from 8 years
and above and persons with reduced
physical, sensory or mental capabilities
or lack of experience and knowledge
if they have been given supervision
or instruction concerning use of the
appliance in a safe way and understand
the hazards involved. Children shall
not play with the appliance because
this is not a toy. Cleaning and user
maintenance shall not be made by
children without supervision.
2) WARNING: disconnect all submerged
electrical appliances in the pond
before carrying out installation and
maintenance operations.
3) The power cord must not be repaired
or replaced. If it is damaged, replace the
entire pump unit.
4) This appliance must be supplied
through a residual current device (RCD)
having a rated residual current not
exceeding 30mA (Idn ≤ 30 mA).
5) If the connection plug or the electric socket should be
wet, disconnect the master switch before pulling out the
power supply cable.
6) Check that the voltage given on the appliance label
corresponds to the mains voltage.
7) Before connecting the appliance to the mains, check that
the cable and the appliance are not damaged in any way.
8) The appliance power supply cable must form an
appropriate loop, facing downwards (DRIP LOOP -fig.
1 on page 39), to prevent any runoff water from coming
into contact with the socket itself.
9) Do not place the supply cable underground, but
follow the installation instructions prescribed by the
local regulations in force, and consult a qualified
installer and electrician.
10) When installing the appliance, do not use the supply
cable to lift it.
11) Before starting up the appliance, check that it has

English

been correctly installed.
12) Do not use or keep the appliance in an area subject
to freezing. In winter, it is necessary to remove, empty
and position the appliance so that it is protected.
13) The appliance must not be operated dry.
14) Avoid using corrosive or abrasive liquids when
operating these appliances.
15) The maximum temperature for the circulating liquid
must not exceed 35°C.
16) The pump must be connected to an earthed socket.
17) The pump can be submerged into water up to a
maximum depth, as indicated by the symbol
appliance (fig. 1 on page 39).
18) WARNING: For CASCATA adv 8000 only (fig.2
on page 39). This appliance uses a particularly
powerful magnet. Consequently the magnetic field
that is produced out from the pump motor can cause
malfunctioning or electronic or mechanical failures to
other appliances. For this reason it is recommended
to keep a distance of at least 30 cm from magnet
to pace-makers, credit cards, cash-point cards,
magnetic keys or others (check on the instructions
manuals of the relative appliances). Additionally, in
order to reduce risk of squeezing pay attention during
the maintenance operations and during clearing
operations of the rotor-impeller. Also in this case it is
recommended to keep the magnet at least 10 cm far
from any surface or metallic objects to avoid abrupt
magnetic attraction.
WARNING: Risk of electric shock - this pump is
supplied with a ground conductor and ground-type
attachment plug. To reduce the risk of electric shock,
be certain that it is connected only to a properly
grounded, ground-type receptacle.
CAUTION: This pump has been evaluated for use with
fresh water only.
ADDITIONAL SAFETY INSTRUCTIONS
• This appliance is intended to be permanently
connected to the mains, other than by means of a
plug and socket.
• A 3-amp fuse must be fitted in the supply circuit.
• A complete disconnection of all electrical poles
must be made possible. All wiring must be in
accordance to Overvoltage Category III conditions
and to the local wiring rules.
• The wires in this main lead are coloured in
accordance with the following code: BROWN=LINE,
BLUE=NEUTRAL, GREEN/YELLOW=EARTH.
• This operation must be carried out by a qualified
electrician.
SAVE THESE INSTRUCTIONS CAREFULLY!
4 / 48
• ONLY FOR UK •
on the