Control Panel - G21 Smart Smoothie Vitality Manual Del Usuario

Control panel

LCD screen
If the appliance is connected to an electrical outlet, the LCD display shows time 00:00 and speed
number 3.
The appliance is in the standby mode and all the buttons light.
Manual setting
Time + Time -
+
To set the operating time (from 5 seconds to 30 minutes).
• Tip: hold button to set the time faster
Speed + Speed -
-
To set the operating speed (1-2-3-4-5-6-7-8-H).
• Tip: in manual mode the speed and time is adjustable during operation.
Pulse
Caution: pulse function runs the appliance at the highest speed, therefore make
sure that the cover is properly attached.
• Tip: pulse operation may be used to clean the jar.
Preset programs
Press any programmable button. It starts to blink. The corresponding program is
displayed on the LCD screen. At this time you can adjust the time and speed of
mixing. After starting the program you cannot change time and speed.
ON/OFF
The button will start to flash, the selected program button stops to flash and glows,
all other programmable buttons turn off. The time on the LCD display will start to
decrease.
• Speed + - and Time + - are adjustable before starting the program, after starting
the program you cannot change time and speed.
Veggie
Press this button to process fruits and vegetables, the speed starts from 1 to H
within 5 seconds and the appliance starts to work at highest speed for 2 minutes.
• Speed + - and Time + - are adjustable before starting the program, after starting
the program you cannot change time and speed.
Soup
Press this button to process soup, the speed starts from 1 to H within 9 seconds,
then the appliance is working at highest speed for 3,5 minutes.
• Speed + - and Time + - are adjustable before starting the program, after starting
the program you cannot change time and speed.
Sauce
press this button to process sauce, the speed starts from 1 to 5 within 3 seconds,
then the appliance is working at middle speed 5 for 2,5 minutes.
• Speed + - and Time + - are adjustable before starting the program, after starting
the program you cannot change time and speed.