Assembly; Instructions - mill CUS1500MECWA Manual Del Usuario

millheat.com

Assembly

See figure 3 on separate illustration sheet
1. The heater should be unplugged during assembly or disassembly.
2. Remove the pre-mounted screws on both legs before you insert them into the
brackets, so that you get a stable foot.
3. Attach the legs to the brackets by tightening 2 screws into each bracket. Do not tighten
completely in order to fit the foot into the square tracks of the heater.
4. Place the heater gently on its head and use the supplied screws to mount
the feet.
5. Place the foot in the square tracks and fasten each foot bracket with two screws.
Wait to tighten the screws until all four screws have been fastened. You can now tighten
the screws attaching the legs and brackets.
6. A er the assembly is complete return the heater to its upright position before operation.
7. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.

Instructions

Control Panel
See figure 4 on separate illustration sheet
1. Thermostat: Adjust the desired heat setting
2. Output selector:
O: OFF
Fan (only fan, no heating)
I: 1000W
II: 1500W
WARNING! BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION! This heater is only meant to be used as a supplementary heating
source, and must not be used without supervision
Usage
1. Set the output selector to the OFF position (O) and the thermostat to minimum. Plug the heater
into a grounded outlet.
2. Set the output selector to position
3. Set the output selector to position I or II. Turn the thermostat up to the maximum position.
When the desired room temperature has been reached, turn the thermostat slowely down
until you hear a click. The thermostat can now remain in this position until a di erent room
temperature is desired. As soon as the room temperature falls below this level, the heater will
automatically switch on again. When the room has again reached the desired temperature,
the heater will switch o again.
4. lf you wish to change the room temperature, repeat the instructions in step 3.
5. The heater has on overheat protection that turns the device o if any parts become
extremely hot.
6. To switch the heater o , turn the output selector to the O position. lf the heater will be le
unused for a longer period of time, pull the plug.
for fan only (no heating).
7