Weston 07-3103-W Manual De Instrucciones página 3

1. Insert the Blade Assembly into the
lower housing, guiding the drive shaft into
the journals. Make sure the gears and the
blades of the Blade Assembly are properly
meshed together and resting in the journals
(Figure A). NOTE: The Tenderizer Blade
is a 2-piece set. The Jerky Slicer Blade is
a single piece.
Sold Separately
2. Position the top housing onto the lower
housing and line up the screw holes.
3. Secure the top housing to the lower
housing using the 2 housing thumbscrews.
DO NOT OVERTIGHTEN! (Figure B).
4. Insert the left comb and right comb into
the top housing (Figure B).
NOTE: The left comb is marked with an "L"
on the upper portion of the comb. The top
housing is marked with an "L comb" and "R
comb" to aid in comb installation.
5. Install handle onto the Blade Drive
Shaft. Secure the Handle to Drive Shaft
with the Handle Thumbscrew (Figure C).
NOTE: Periodically the gears on the
Blades need to be tightened. Use the
allen wrench to tighten the screw on the
gears.
ASSEMBLY INSTRUCTIONS
Gears
Gears
Jerky blades and
Cuber/Tenderizer Blades
sold separately
Top
Housing
Journals
Lower
Housing
Housing
Thumbscrews (2)
-3-
Figure A
Blade
Assembly
Drive Shaft
Journals
Figure B
Figure C
Drive Shaft
Handle
Thumbscrew
Handle