Write Key; Set Language; Keypad Lock - Paradox ESPRIT+ 642 Guia De Instalacion

(messages) from a Paradox Memory Key to the keypad's memory.
Insert a programmed Paradox Memory Key into the keypad
connector labelled "key" (see Figure 1 on page 29). After entering
Keypad Programming Mode, select section [4] and then press the
] key. The display reads: Reading Key. The keypad will
[
ENTER
copy the contents from the key into keypad memory. This may take
approximately 15 seconds. Once the information has been copied,
the keypad will emit a confirmation beep.

[5] Write Key

Use this option to copy the programmed options and labels
(messages) from a keypad to a Paradox Memory Key. Insert the
Paradox Memory Key into the keypad connector labelled "key" (see
Figure 1 on page 29). Make sure the Memory Key's jumper is on.
After entering Keypad Programming Mode, select section [5] and
then press [
ENTER
take approximately 15 seconds. When the process is complete, the
keypad will emit a confirmation beep. Program one keypad, copy its
contents to the memory key as explained in this option, then program
as many keypads as required using option [4] (see above).

[6] Set Language

Use this option to set the keypad's display language. Depending on
which language set you ordered, the keypad can store up to 9
languages. Use the [ ] [ ] keys to scroll through the list. Press
] to save the selection.
[
ENTER

[7] Keypad Lock

Use this section to prevent your keypad code from being set to default in
case of an accidental or unauthorized event. After selecting section [7],
press keys [1], [4], and [7] to lock your code, and then press the [
]. The display will read: Writing Key. This may
]
ENTER
Esprit+ 642 9