Plantronics CT10 Manual De Usuario página 12

STEP 1
SETUP THE REMOTE
PREPARING THE REMOTE FOR USE
Remove the paper separator between the Remote
Rechargeable Battery
Note: If the paper rips before coming out. The Remote and the
Rechargeable Battery Pack can be separated by sliding the Remote up
and the Battery Pack down. They can be reassembled by reversing this
action.
Plug the Headset into the Headset Jack
the Cable into the Headset Cable Retainer
CHARGE THE REMOTE
Firmly slide the Remote
Battery Charge Indicator Light
The Battery Charge Indicator Light will go off
when the battery is fully charged.
(It's important to make good contact in the
charging well to properly charge the battery.)
The Remote may be operated while in its Charging Well after gaining
5 seconds of orientation. The Charge Indicator Light will stop flickering
when orientation is attained.
Once charged, the Remote can be operated away from the Base.
by pulling it out.
on the Remote
into the Remote Charging Well
flashes.
7
and the
and snap
.
until the
B
C
D
E
G
E