Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
|
BEFORE CALLING FOR SERVICE (continued)
Bleach or softener dispensed
too
soon.
Bleach or softener was added
directly to the wash load in the drum.
VVasher was not unloaded promptly.
Clothes were not properly
sorted.
Dispenser compa_ment
is overfilled causing
bleach or softener to dispense immediately.
Dispenser drawer closed too quickly causing
bleach or softener to dispense immediately.
Laundry chemicals must be loaded into the
dispenser.
Always remove items from the washer as soon
as possible after the cycle is complete.
Always wash dark colors separately from light
colors and whites to prevent discoloration.
Never wash heavily
soiled items with lightly
soiled items.
Washer
will not turn ON
Power cord is not properly
plugged
in.
Make
sure that the plug is plugged
securely
into
a grounded,
3-prong,
]20-VAC,
60-Hz
outlet.
House fuse is blown, circuit breaker
has tripped, or power outage has
occurred.
House fuse is blown, circuit breaker
has tripped, due to multiple
appliances on one outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity, if the problem is a circuit
overload,
have it corrected
by a qualified
electrician.
Reset circuit breaker or replace fuse. If more
than one appliance is connected to the outlet,
call an electrician to have an additional
circuit
installed.
Door will not unlock
Interior tempe_re
of washer istoo high.
The washer door has a safety feature
to prevent
when
cycle is stopped or
personal
injury. For example,
if the washer is
paused
during the hot wash stage of a sanitize
cycle, the interior temperature
of the drum will
be very hot, so the door will not unlock.
This
is normal.
Allow
the washer to cool until the
DOOR
LOCI< indicator turns OFF on the display.
Water
level in washer is too high.
To drain the water_ press POV'/ER, then press the
SPIN SPEED button
without
selecting
a cycle.
Wash c_.Je tlme is Io_
The washer a_omatically
adjusts the
This is normal. The washer adjusts cycle time auto-
than usual
wash time for the amount of laundry,
maticalty
to provide optimal results for the selected
water pressure, water heating time and
cycle. The time remaining shown in the display is only
other operating
conditions,
an estimate, Actual time may vary,
Music€ or mildewy
odor in
incorrect
or too much detergent
has
Use only High-Efficiency
(HE) detergent
in
washer
been used.
accordance
with the manufacturer's
instructions.
Inside of drum was not cleaned
prop-
erly.
Washer
not unloaded
promptly.
Washer
overloaded,
Hot and cold water inlet hoses are
reversed.
Run the CLEAN VCASHERo cycle regularly. Be
sure to wipe around and under the door seal
frequently. See Care and Cleaning of the Inte-
rior.
Clean around door seal/glass to prevent odor.
Always remove items from the washer as soon
as the cycle is complete.
When washing large loads, do not overstuff the
drum. The washer can be fully loaded, but the
drum should not be tightly packed and the door
should close easily.
Hot water rinse can set wrinkles in garments.
Check the inlet hose connections.
3O
Publicidad
Tabla de contenido
