flir Lorex LNZ32P12 Serie Manual De Instrucciones página 14

Ocultar thumbs Ver también para Lorex LNZ32P12 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4
Installation
To install the camera on a ceiling:
CAUTION
Make sure to disconnect power before installing the camera. Camera will begin moving immediately
when power is connected.
Make sure to install the camera in a location that can support the camera weight.
1. Remove plastic film from the screw holes on the bottom of the camera.
2. Use the included mounting template to mark holes for the mounting screws and cables
if needed. Drill where marked.
NOTE
If you run the cables along the mounting surface, you must run the cable through the cable notch on
the base of the camera. This will keep the camera base flush to the surface when mounted.
3. Use the included Allen key to loosen the dome cover screws (x3). Remove the dome
cover.
4. Remove the foam ring* around the camera module.
5. Connect the camera to the cabling in the ceiling. See 3 Connecting the Camera, page
3 for full connection instructions.
#LX400020; r.35429/35429; en-US
11

Publicidad

Tabla de contenido
loading

Tabla de contenido