Cisco Systems LINKSYS NSLU2 Guia De Inicio Rapido página 6

E
If you already have a router or other
DHCP server automatically
assigning IP addresses, then select
Automatically obtain an IP
address (DHCP) and click Next.
Proceed to Step F.
To set the Network Storage Link's IP
address and network information,
select Set IP configuration
manually and enter the following
information:
• IP Address. Enter the Network
Storage Link's IP address, and
make sure that it is on the same
local area network (LAN) segment
as the PC running the Setup
Wizard.
• IP Mask. Enter the Subnet Mask,
which must match the subnet
mask of the other devices on your
network. The default is
255.255.255.0.
• Gateway. This field is left blank by
default. However, if you have a
router on your network, enter its IP
address in this field.
Click the Next button.
F
On the Date/Time Settings screen,
select your local time zone. Then set
the current date and time. Click
Next.
G
Review the Network Storage Link's
settings. If they are correct, click
Save. If you would like to change
them, click Back to return to a
previous screen.
6
E
F
G