Ø1/4" x 45 mm Bolt
(8 used in this step)
22. Now, place the two assembled bunks where you want to place your loft bed.
23. Insert four Bed Connector Pins (11) into the Lower Posts (A, B, C and D) and secure them in place with
the 45 mm Bolts (2). When attaching the Connector Pin (11) to Lower Headboard Front Post (A), you
will need to insert one 45 mm Bolt (2) through the bottom hole of the Metal Bracket (14) and screw into
the threaded hole of Connector Pin.
24. Now, ask for assistance to stack the Upper Bunk onto the Bed Connector Pins (11) on the Lower Posts
and fasten the Upper Posts (E, F, G and H) in place with four 45 mm Bolts (2). Proceed to insert two 19
mm Screws (13) through the countersunk holes of Metal Bracket (14) and securely screw into place.
NOTE: Make sure that the Upper Bunk sits completely on top of the posts and the pins go all the way,
not leaving any gaps.
ASSEMBLY OF THE BUNK BED
Bed Connector Pin
(4 used in this step)
②
⑪
Ø3.5 mm x 19 mm Screw
(2 used in this step)
⑬
18
Metal Bracket
(1 used in this step)
⑭