Omega 13060 Manual De Piezas E Instrucciones De Funcionamiento página 3

(Refer to Parts Breakdown)
PREPARATION
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
2. Verify that the product and application are compatible, if in doubt call Omega Technical Service (888) 332-6419.
3. Assemble handle, ensure spring clips align with slots.
4. To familiarize yourself with basic operation, use the notched end of provided Pump Handle to engage and turn
the Release Valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' Release Valve position used to
raise the ram plunger.
b. Counter-clockwise, but no more than 1/2 turn from the closed position. This is the 'OPEN' Release Valve position
used to lower the Ram Plunger.
5. Install vent screw (for models 13120 and 13200 only). With Ram Plunger fully retracted and release valve closed,
pump the operating handle. If Ram Plunger responds immediately, jack is ready for use. If jack does not respond,
follow Bleeding/Venting Trapped Air instruction below.
6. Check that the pump operates smoothly and that the Extension Screw will thread up/down easily before putting
into service. Replace worn or damaged parts and assemblies with Omega authorized replacement parts only.
Bleeding/Venting Trapped Air
With the Release Valve in the OPEN position (4b above) and with Ram Plunger fully lowered, locate and remove
the vent plug/screw. Insert the Pump Handle into the Handle Sleeve; then pump 6 to 8 full strokes. This will help
release any pressurized air which may be trapped within the reservoir. Oil level should be even with the bottom of
the oil filler hole. Reinstall the Oil Filler Plug/Screw.
Head Saddle
Vent Plug/ Screw
Carry Handle
Return Spring
Handle Sleeve
Release Valve
Figure 1 - 13060, 13120 & 13200 Nomenclature
Toe Saddle
3
Handle