Mestra Autopol Geisser Manual Original página 12

Automatic polymerisation pot
NOTE: Read this manual carefully. It contains im-
portant information about safety during instal-
lation, use and maintenance. If the equipment
is utilized in a manner not indicated by the
manufacturer, the safety provided by the
equipment may be adversely affected.
Meaning of the symbols used in rela-
tion to the machine
Danger. Danger of injuries.
Read these instructions in their en-
tirety before putting the device into
operation.
Risk of electric shock.
Caution: the surface of the lid
and the pot, the water and the
steam at 100 °C, can cause burns.
Use suitable protection.
Water outlet connection.
Pressurised air inlet connection.
Outlet of steam at 100 ºC / 212 ºF.
Precautions
▪ Keep this manual in a suitable place for future refer-
ence.
▪ Check the general conditions of the device immedi-
ately after removing the packaging.
▪ Breakdown caused by incorrect installation or incor-
rect use of the device is excluded from the guarantee.
▪ To avoid the risk of electric shock, this device must
only be connected to a power supply with proper
earthing. Before connecting the device, check that the
identification label indicates the correct voltage. The
installation must comply with all applicable safety
standards.
▪ Remove any remains of dirt or water from the con-
nection of the cable.
12
▪ Avoid excessive traction, twisting or folding of the
cable for connection to the electricity grid.
▪ Do not touch the device or the cable with wet or
moist hands.
▪ Install the product away from sources of heat, dust,
high humidity, and from splashing of water or in-
flammable material (alcohol, solvents, etc.).
▪ Unplug the device immediately if you detect noise,
smells or smoke.
▪ Ensure that children and unspecialized staff do not
handle the device.
▪ If in doubt, do not put the device into operation. Con-
tact a qualified and authorized repairer.
▪ Do not disassemble, repair or modify the device.
▪ Unplug the device if there is a storm, and when out of
use for a long time.
▪ Unplug the device before cleaning it, do not wet it di-
rectly, and do not use chemical products.
▪ Contact your distributor if you have any questions or
for detailed information about problem solving.
▪ Before using the device, ensure that it is positioned
on a firm and solid base.
▪ The cable can only be replaced by one with identical
characteristics to that supplied by the manufacturer.
▪ Protect yourself properly; use gloves and safety
glasses.
▪ Do not allow anybody to bridge the safety systems.
▪ Do not use the machine for any use other than its in-
tended purpose.
Intended use
The Ref. 030425 is a polymerisation pot, easy to handle
and especially designed for the polymerisation of pros-
theses and other elements within the dental prosthesis
sector.
Installation
1. Carefully unpack the unit. Check that it has not suf-
fered any deterioration during transport.
2. Place the device on a firm, flat surface away from
any focus of heat or vibrations.
3. Connect one end of the Ø 4x6 tube to the air inlet
(H). Connect the other end to a source of pressurised
air (minimum 3 bar).
4. Choose a position for the drainage bottle in a place
located at least 20 cm below the bottom of the ma-
chine. The water expelled from the tank is at boiling
temperature, which means that an accidental fall of
the bottle can cause an accident. Therefore, take care
that the position of the drainage bottle ensures opti-
mum stability and safety. Once the bottle is in posi-
tion, connect the Ø 6x8 drainage tube to the outlet
(G), and insert the other end into the upper orifice of
the bottle.

EN