Mestra Autopol Geisser Manual Original página 16

bEEP
Cycle end warning time (seconds).
5
2. Use the keys and
sec). If you select the value "ON", warning will the
warning will remain indefinitely until a key is
pressed.
3. Press again the key
move on to the next parameter.
dE9r
Temperature in Celsius degrees.
o
C
4. Use the keys and
and ºF.
5. Press again the key
Error messages
E-01
Broken interior thermal probe.
E-02
Broken resistor sensor.
E-10
The safety thermostatic switch actu-
ated.
E-20
Interior overheating
E-21
Resistor overheating
E-22
Electronic controls overheating
E-80
Electricity supply cut
E-81
Lack of water
E-82
Excessive waiting time
* Technical service actuation is needed.
** Press any key to erase the error message.
Safety elements
The machine has the following safety elements:
▪ Air inlet pressure regulator.
▪ Safety valve on lid.
▪ Interior safety valve.
▪ Detection of anomalies by electronic control.
▪ Resistor temperature sensor.
▪ Safety thermostat.
to modify values (0-30
to validate the value and
to change between ºC
to validate the value.
*
*
*
*
*
*
**
**
**
Maintenance and cleaning
To ensure optimum reliability and long life of the
device, we recommend:
▪ After each use, we recommend cleaning away remains
of materials from inside the tank with normal washing
up liquid. In order to do so, remove the plastic plate
from the bottom of the tank and clean the inside of the
tank, taking care not to damage the temperature probe.
Rinse the inside of the tank with abundant water.
▪ To prevent remains of material from obstructing the
exit from the tank, clean the inside of the tank
periodically (approx. every 5 uses). To do so, heat the
water to a temperature of 100 °C. Then empty the tank
through to the drainage bottle.
▪ Periodically, and depending on water hardness, clean
away remains of limescale which may have been
deposited on the bottom of the tank.
▪ Do not use solvents or any other inflammable product.
▪ Proceed with caution when handling the lid in order
not to bash it (there are safety valves inside).
▪ Replace the rubber seal of the lid periodically. For this
operation, we recommend using original MESTRA
replacements.
▪ If you feel excessive resistance when turning the lids,
or it does not seal well, you can clean the rubber seal
and lubricate it lightly with talcum powder.
Technical characteristics
Height: ................................................................... 35 cm
Width: .................................................................... 36 cm
Length: ................................................................... 40 cm
Weight: .................................................................. 5,5 kg
Pressure: ................................................................... 2 bar
Maximum temperature:......................................... 100 ºC
Tank capacity: ............................................................ 6 L
Tank dimensions: ........................................ Ø22 x 15 cm
Heating power: ...................................................... 600 W
UE statement of conformity
The company Talleres Mestraitua S.L.
with social address: Txori-erri Etorbidea, 60
48150 Sondika - Bilbao - Spain
hereby declares that the product
Automatic polymerisation pot 030425
Meets the requirements set out in the following direc-
tives:
2014/35/UE (low voltage)
2014/30/UE (electro magnetic compatibility)
2006/42/CE (machinery safety)
Ignacio Mestraitua
Managing Director
Sondika, 2019-07-08