Festo SPC200 Manual Del Usario página 13

1 User instructionsEnglish
The field bus module type SPC200−COM−PDP enables the
SPC200 to be coupled to the PROFIBUS−DP (as per
EN 50170 part 2). With this field bus module the SPC200
can be operated as a slave on the PROFIBUS−DP. For user−
friendly commissioning you will require the WinPISA soft
ware package as from version 4.1. In order to use the para
meter channel, you will require a field bus module with
firmware version as from V 2.0, an SPC200 with operating
system version as from V 4.6 and WinPISA as from V 4.3.
Detailed information on the field bus module can be found
in the manual P.BE−SPC200−COM−PDP... .
Caution
Please observe:
the technical safety instructions contained therein.
the designated use of the relevant components and
modules.
Warning
Actuators may make sudden unexpected movements
and the SPC200 will be damaged if modules are added
or removed whilst the power supply is switched on.
Before carrying out installation and/or maintenance
work, switch off the following power supplies in the
sequence specified:
1. the compressed air supply
2. the load voltage and operating voltage supplies of
the SPC200.
Festo SPC200−COM−PDP 0302a English 13