Foreword; Declaration Of Conformity; European Directive Rohs 2012/19/Ue; Transport And Packaging Removal - Diamond AMHF/312-P Instrucciones Para La Instalación, Uso Y Mantenimiento

FOREWORD

The contents of this manual are generic and not all the functions described may be available on your
product.
The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing
or copy errors. We reserve the right to make on our own products those changes to be considered necessary or
useful, without jeopardizing the essential characteristics.
Read the instructions for use very carefully paying particular attention to the rules concerning safety devices. This
appliance must only be used for what it has been designed for and built for and that is: all baking of dishes and
regenerating pre-cooked and/or frozen food.
WARNING!
Before making any type of connection of this equipment, carefully read the instructions in this manual.
This manual must be carefully kept to be available for future reference by users or service technicians.
Installation must be carried out by d qualified personnel only.

1.0 DECLARATION OF CONFORMITY

The Manufacturer declares that the appliances conform to the EEC norms.
They must be installed in accordance with current standards, especially regarding aeration of the premises and the
exhaust gas evacuation system.
Note: The Manufacturer declines all and every responsibility for any direct damages caused by: an in-
correct use, wrong installation or bad maintenance.

1.1 EUROPEAN DIRECTIVE ROHS 2012/19/UE

This appliance is marked according to the European directive 2012/19/UE on Waste Electrical and Electronic Equip-
ment (WEEE). By ensuring this product is disposed correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by inappropriate waste handling of this
product.
The symbol on the product, or on the documents accompanying the product, indicates that this
appliance may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste dis-
posal.

1.3 TRANSPORT AND PACKAGING REMOVAL

Upon receipt of the oven and before installing it, check the packaging is intact and there are not visible damages.
Also check that along with the oven you receive also the documentation, consisting of:
• Instructions for installation, use and maintenance
• Wiring diagram
Before bringing the prover to the point, where it must be installed, check the following:
The doors are large enough to allow passage of the oven
The floor supports the weight.
According to the model of prover, its dimensions and its weight, use suitable facilities to handle goods during trans-
port and installation, able to guarantee stability in order to avoid overturning, falls or uncontrolled movements of
the appliance or its components.
Keep the prover packed until you reach the site where the oven is going to be installed.
The packaging makes the handling of goods easier and protects the oven from accidental push.
During moving and installation, the installer must comply with accident-prevention regulations in force at the place
of installation (use of safety shoes, gloves, etc.) Remove the packaging taking care not to damage the prover.
The adhesive film, that protects the surfaces made of stainless steel can be removed also after you have positioned
the oven on the support surface.
ATTENTION: Packaging materials and adhesive film are potentially dangerous.
For this reason, they must be kept out of the reach of children and properly disposed of in com-
pliance with local directives.
You should separate packaging materials (wood, cardboard, plastic...) and dispose of them se-
parately, in compliance with directives in force at installation site.
Note: Take the protective film off the stainless steel parts by hand before starting the appliance.
Do not use abrasive substances and/or metal objects. Clear any adhesive residues using a sponge soaked in sol-
vent. If the prover is heated up before removing the adhesive film, the removal of the film and cleaning of residues
of glue will be much more difficult.
7
EN