Forest-Master FM16 Manual De Instrucciones página 16

RAM STOP
Loosen the knob on the ram stop so
that it is free to slide on the bar.
Operate the log splitter to move the
ram forward to the required length.
Holding the operating lever in place
to ensure the ram does not return,
position the ram stop against the
front of the splitter and tighten
using the knob. The ram stop can be
adjusted by simply unscrewing the
knob and sliding along the cradle
bar, the ram may need to be moved
forward depending on the length of
log you wish to split. The operating
lever must be held in place when
unscrewing the ram stop or the ram
will return.
16
IMPORTANT: Ensure the motor is switched off and only
use the operating lever to hold the ram in position
when adjusting the ram stop.
Ram Stop
FM16(D/T/TW/P)