Installation Instructions; Connection Cable - Electrolux EHF6232FOK Manual De Instrucciones

10 www.electrolux.com
The appliance deacti-
vates.
The residual heat indica-
tor does not comes on.
You cannot activate the
outer ring.
The sensor fields become
hot.
comes on.
comes on.
and number comes
on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.

8. INSTALLATION INSTRUCTIONS

WARNING!
Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
Problem Possible cause
You put something on the
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cookware is too large
or you put it too near to
the controls.
The Automatic Switch Off
operates.
The Child Safety Device
function operates.
There is an error in the
appliance.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into correct
built-in units and work surfaces that
align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-
nection cable.
Remedy
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Activate the inner ring
first.
Put large cookware on
the rear cooking zones if
necessary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.