Cosatto ZOOMI NITTY GRRITTY Manual De Instrucciones página 14

At the back of the child car seat, unclip the chest pad strap (c) and the shoulder straps
(d) from their connectors.
Feed the strap ends through the seat until they are clear of the cover (e).
Re-thread the chest pad straps (f) and then the shoulder straps (g) back through your
chosen shoulder slot. Make sure the straps are not twisted.
Hook the shoulder straps (h) and the chest pad strap (i) back onto the connectors
ensuring they fit correctly.
Pull the adjustment strap forward to remove any slack (j).nhhj
5 - installation of the car seat - Group 1 (9 to 18kg, approx 9
months to 4 years old)
NOTE: The vehicle seat belt clip is not required for Group 1
installation. The vehicle seat belt clip can be stored in the pocket on
the rear of the backrest fabric cover or kept in a safe place for future
use.
Place the child car seat in the forward facing position on the vehicle car seat.
Pull the vehicle seat belt and thread the diagonal belt through the red fabric seat belt
slot (a) and the lap strap under the seat belt guide (b). The seat belt slot is marked by
a red arrow on a tag. At the back of the seat feed the seat belt under the harness and
through the other seat belt slot (c). Pass the upper part of the vehicle seat belt over
the other seat belt guide and the lower part of the vehicle seat belt under the seat
belt guide (d) then fasten the vehicle seat belt.
Carefully kneel on the child car seat to push it into the vehicle seat. Pull the seat belt
at (e) to tighten the lap section of the belt then pull the diagonal section of the seat
belt tight at (f). The child car seat should now be secure.
IMPORTANT: The position of the vehicle seat belt buckle can affect
the stability of the child car seat. In an accident this could stop the
child car seat from protecting your child as well as it should. If,
when the vehicle seat belt is properly tightened, the buckle lies in
the position marked then try fitting the child car seat in another
seating position in your vehicle.
6 - seating your child into the car seat harness
Loosen the harness by pushing the adjuster button (a) in as you pull under the
shoulder straps (b) forward as much as possible.
Unfasten the harness buckle by pressing the red button (c) and releasing the shoulder straps (d).
Place your child in the seat.
Fit the harness around your child and fasten the harness buckle by joining the shoulder
straps (e) and pushing them both into the buckle (f).
Check that the harness is not twisted and pull the harness up (g) to tighten the lap
sections which is designed to fit low down on your child's body.