Cleaning The Storage Drawer; Troubleshooting; Replacing The Oven Light; Possible Cause - Furrion FT24N62R-SS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Follow the steps below to re-attach to the oven door
(Fig. 30):
− Insert the hinge into the top slot as shown in Fig 30
− Open the door to its fully open position as shown
in Fig 30
b
. Ensure the hinge buckle has released from
the lever as shown in Fig 30
a
Fig. 30

Cleaning the Storage Drawer

1. Lift the left small hook upward, at the same time, push the
right small hook downward. (Fig. 31)
Fig. 31
2. Pull the drawer out.
3. To replace the drawer, align the drawer with the rails and
push inward.
NOTE: Do not store flammable material in the oven or in the
bottom drawer.

Troubleshooting

Problem
Surface units will not maintain a
rolling boil or frying rate is not fast
enough
Surface units do not operate
Control knobs will not turn
Oven light does not work
Oven does not work
17
c
.
c
Lever
Hinge
b
● You must use pans that are absolutely flat.
● Pan bottoms should closely match the diameter of the surface unit selected.
● The control knob is to low of setting.
● You have blown a household fuse or tripped a circuit breaker.
● You have not set the control knobs correctly.
● If it is a surface unit control knob, you are not pushing in before turning.
● If it is oven control knob, you are trying to turn the knob in the wrong direction.
● Light bulb is loose or has burned out.
● Oven function knob was set to OFF.
● You have blown a household fuse or tripped a circuit breaker.
● You have not set the control knobs correctly:
− Oven function knob was set to OFF. Select the light function on the control
panel.
− Oven thermostat knob was set to OFF.

Replacing the Oven Light

a
.
● Disconnect electrical power before servicing.
● Replace all parts and panels before operating.
● Failure to do so can result in death or electrical
shock.
● Let the oven cavity and broil burner cool down.
● Switch off the electric supply.
● Remove the light cover by rotating to the left. (Fig. 32)
Fig. 32
● Unscrew and replace the halogen bulb with a new one
suitable for high temperature (300°C ~ 570°C) having the
same specifications: 240V 60Hz, 25W, G9.
● Replace the protective cover.
NOTE: Oven bulb replacement is not covered by your
guarantee.

Possible Cause

WARNING
ELECTRIC SHOCK HAZARD

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ft24n62c-ss

Tabla de contenido