Setting Optimum Start Control; Tp7000 Wiring (Not Rf Models) - Danfoss TP7000 Range Guia De Instalacion

7-day - each day can be programmed with diff erent times and
temperatures.
5/2 day - one set of times & temperatures for weekdays, and another
set for weekends.
Optimum start control - function which switches the heating on
earlier than the Event 1 programmed time to ensure the required
temperature is achieved by the set time.
Chrono-proportional control - energy saving feature which fi res the
boiler at regular intervals to maintain a set temperature, achieving a
GB
constant ambient environment for the user.
F

3.2 Setting Optimum Start Control

Set Sw2 to OSC ON
D
(see DIL settings page 4)
Select OPTIMISER CURVE in
ES
programming mode
A Event 1 Set Point
DK
B Deviation from Set Point
C Switch On Time prior to Event
NL
D Optimiser Curve Setting
I

3.3 TP7000 Wiring (not RF models)

GR
PL
LT
1
CZ
COM
M 24V models only
HR
B
RO
Note: 1.0mm
remote sensor to the TP7000A. Please ensure that:
a) the cable length does not exceed 50 metres,
b) to avoid electrical interference the cable should not be run
parallel in close proximity to other cables carrying mains electricity,
and where necessary the cable should cross over mains cabling at
right angles.
6
2 3
OFF
ON
M 230V models only
C L
24V
230V
2 solid copper cable should be used to connect the
A
-1°C
-2°C
B
-3°C
-4°C
120
min.
ELECTRONICS
4 5 6 7
REMOTE
N
SENSOR
'A' models
only
D
30 Event 1
90 60
min. min. time (0)
min.
C
TP7000 RANGE