arietta AAR428SSA Guía De Instrucciones Para Instalación página 7

Recirculating through
A
B
G
C
F
D
E
A. Ceiling
B. Recirculating grid
C. Soffit
D. 6" round vent system
1.
Measure and mark the centerline of the cabinet to the soffit
above.
2. Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soffit or cabinet top
wall. Mark the location and use a saber saw or keyhole saw to
cut a 5¾" (14.6 cm) hole for the vent cover.
A
A. Vent cover
B. Centerline
*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3. Consider the cutout chart measures to make the openings on
the cabinet.
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow the
6" vent and vent cover to be seen.
4. Cover the grill that protects the suction motor with the carbon
filter so that the slots on the filter correspond to the pins on
the sides of the motor protection grill.
5. Turn the carbon filter clockwise to block them (bayonet fixing).
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
You must cut the cable tie attached to the blower to make a
proper installation.
the soffit
E. Range hood
F. Cabinet
G.Wall
B
Complete Preparation
1. If not yet attached, install the 6" (15.2 cm) vent transition the
top of the range hood liner using two 3.5 x 9.5 mm screws.
2. Locate side mounting bracket flush 1 cm to the bottom of the
cabinet side and against the inside of the front cabinet face.
Orient the bracket depending on the width of your cabinet as
depicted in the diagrams below. Using the bracket as a
template, mark 4 spots in each side of the cabinet to drill
⁄ " (3 mm) pilot holes. Attach a bracket using four 4.5 x 13
1
8
mm screws to each side of the cabinet, and tighten.
Additional washers in hardware package are supplied as
spacers for cabinet walls thinner than ½" (13 mm).
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C.Washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)
Bracket Orientation for 36" (91.4 cm) Cabinet
C
A
B
A. 36" (91.4 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C.Washers (optional)
D. Mounting bracket (2) (position for 36" [91.4 cm] cabinet)
7
C
D
D
Move the bracket ⁄ " (1 cm) from the bottom
6
16
side of the cabinet.
NOTE: For 11 ⁄ " (29.7 cm) depth cabinets,
11
16
the bracket must be centered to lateral walls.