Troubleshooting; Declaration Of Conformity - Tractel dynafor Industrial Serie Manual De Instalación, De Utilización Y De Mantenimiento

Problems
The sensor does not light up
No return to initial zero
No change in the display or inconsistent display.
Linearity or accuracy problem.
Copy of the declaration of conformity in the appendix

12. Troubleshooting

Possible causes
Batteries empty.
Fault in circuitry.
Tare function enabled.
Sensor permanently
deformed due to
incorrect handling,
excessive overload or
compression.
Malfunctioning sensor or
circuitry.
Malfunctioning sensor or
circuitry.
Sensor subject to
compressive or torsional
stress.

13. Declaration of conformity

Remedies
Replace the batteries.
Contact Tractel®
Disable the Tare function and
display the "GROSS" value of
the force.
The product must not be used
before it is verified by Tractel®.
Reset: Switch the sensor off and
then on.
If the malfunction persists, contact
Tractel®
Contact Tractel®
Eliminate compressive or torsional
stress on the product.
If the malfunction persists, contact
Tractel®
GB
13