Servicing Instructions; Technical Specifications - Nilfisk-Advance SDS 424 Instucciones De Manejo

•
Fill the spray can with the desired product.
•
Fit the drive plate with the desired pad.
•
Start the machine.
•
When you pull the Spraymaster lever a few times the cleaning
agent is sprayed onto the floor. Now start cleaning immediately
until a shine is produced.
•
We advise cleaning the surface in relatively small areas at a time.
The machine is ideal for cleaning with polymer dispersions. The
coating's resistance to foot traffic and general wear and tear is
preserved. Streaks and marks are easier to remove.
Polishing with SDS 424 (380 rpm)
For polishing, equip your machine with the following accessories:
- Drive plate for pads, white pad.
•
Fit the drive plate with the pad.
•
Then start the machine.
Service
•
For repairs, please contact your specialist wholesaler or one of the
service shops.
•
You will be expertly and quickly served.
•
Warning! This machine is only intended for use on level surfaces
with a maximum gradient of up to 2 %.
•
Warning! This machine is not approved for use on public paths
and roads.

Technical specifications

A.C. motor
Rated power
Brush (rpm)
Brush (mm)
Working height (mm)
Working weight
Protection class
Belt-driven
Subject to technical change

Servicing instructions

the following instructions must always be observed
•
When cleaning and servicing the machine, replacing parts or when
changing over to a different function, switch off the drive and re-
move the plug.
•
The power supply lead must not be damaged by driving over it,
crushing, tugging etc.
•
Check the power supply lead regularly for signs of damage.
•
The machine must not be used if the power supply lead is not in
perfect condition.
•
When using or replacing the power supply or equipment supply
leads, use only those specified by the manufacturer.
•
When replacing the plug-and-socket connectors of power supply or
equipment supply leads, splash protection and mechanical
strength must be assured.
•
When transporting the machine in lifts, put the shaft/bar in a verti-
cal position so that it cannot catch on the lift walls.
•
The shaft/bar is automatically secured against recoil by the pat-
ented shaft/bar adjustment unit.
•
Only the spray and cleaning agents suitable for the machine's
purpose may be used.
•
Never use highly flammable, combustible, toxic, health-hazardous,
corrosive or irritant substances.
•
Repairs, including the fitting of spray agent lines and hoses, may
only be carried out by approved customer service shops or by
specialists in this field who are familiar with all the relevant safety
regulations.
Storage
When the machine is not being used, store it in a dry place and in
normal room conditions (not below under 0°C).
SDS 424
220/240 V; 50 Hz
1200 – 1500 W
5,5 – 8,5 A
190 / 380
430
117
35,5 kg
I
x
GB