Eurosystems Euro102 Manual De Instrucciones página 14

is experienced, take action on the belt stretcher control nut).
5 - During working operations, for protection purposes, it is recommended to wear technical/strong shoes and long trousers. Be careful ,
because when machine is operating the danger to be wounded in the toes or feet is really high. Walk, never run with the machine.
6 - During the machine transport and all the maintenance, cleaning, equipment change operations, the engine must be switched off.
7 - Before leaving the machine, please switch the engine off.
8 - Do not switch the machine on in closed rooms/areas where you can have carbon monoxide exhalations.
9 - WARNING !! The petrol/gasoline is highly inflammable: Don't fill the tank neither in closed areas, nor when engine is on, don't smoke and
be careful to the petrol/gasoline loss from the tank. In case of leak, don't try to switch the engine on but move the machine away from the area
in order to avoid ignition source until the gasoline vapours fade away. Re-place the tank caps and the gasoline box.
10 - Keep attention to the exhaust pipe. The parts near the pipe can reach 80°C.
Replace the defective and/or worn out silencers Burn hazards !!!.
11- Don't use the motor hoe on steep slopes: it could overturn!. On slope it is recommended to work crosswise, neither in slope nor in descent
and be vary careful during any change of direction.
12 - Before putting the machine into operations, check it visually and make sure all the accident prevention measures are working. It is
absolutely forbidden to exclude and/or to tamper with them. Replace worn or damaged elements.
13 - In case the machine is incorrectly used, and/or the repairs are performed by non-authorized technical staff, and/or fitted by spare parts
other then original ones: any use other than that described above is prohibited and will involve the cancellation of the warranty and the refuse
all responsibility from the manufacturer.
14 - In the case you are using the transport wheels, from the working area to the storage place, it is necessary to insert the lower gears in
order to reduce the speed.
SAFETY FEATURE (Fig. 6)
n
automatically anytime the respective control lever is released (8).
TRANSPORT
n
A forklift truck should be used to move the machine. The forks should be opened as far as possible and inserted into the pallet.
The weight of the machine is given on the Manufacturer's data plate together with the other technical information.
HOW TO ASSEMBLE YOUR MOTOR-HOE
n
packing case. For assembly to be completed, the step/by/step procedure is as follows.
HANDLEBAR (Fig. 2)
n Attach the handlebar (1) to its mounting (2) using link-rod (3) washer and nut (4) and the swivel between (5) with the
teeth turned towards the operator.
DRAW BAR ARM AND DRAWBAR (Fig. 3)
n
drawbar (5) into the arm end (1), secure with the pin (6) and safety pin (7).
MOUNTING THE HOE-TILLER (Fig. 4)
n
All motor-hoes are provided with a safety feature which acts. The device causes the transmission to disconnect
Unless otherwise agreed, the motor cultivator is delivered disassembled and placed in a
Place the drawbar arm (1) on the arm carrier (2), lock with pin (3) and safety pin (4). Insert
The implement shaft hex. shaped profile allows for quick replacement of implements in
7