Dab Mode - oneConcept 10032325 Manual Del Usuario

EN
20

DAB MODE

1. Press Source button repeatedly to select DAB mode.
2. For initial use, radio will carry out a full scan and store stations list in
memory.
3. Once the scanning has finished, the radio will select the first
alphanumerically found station. To explore the found stations. Press the
or button for selection, when your desired station appears on the display.
Press the select button to confirm your selection.
DAB/DAB+ full scan modes
Press and hold MENU button, turn SELECT knob to select "Full Scan, " and then
press SELECT knob to full scan.
Manual tuning
This can help you when adjusting your antenna or when adding stations that
were missed while auto tuning.
1. Press and hold MENU button, turn SELECT knob to select "Manual tune",
and then press SELECT knob to confirm, the display will show the channel
number and frequency.
2. Press and hold MENU button, turn SELECT knob to select "Manual tune",
and then press SELECT knob to confirm, the display will show the channel
number and frequency. 2. Turn SELECT knob to select the channel you
wanted, and then press SELECT knob to confirm.
DRC (Dynamic Range Control) value
If you are listening to music with high dynamic range in a noisy environment
(for example classical music while cooking), you may wish to compress the
audio dynamic range. This makes quiet sounds louder and loud sounds quieter.
1 Press MENU button, turn SELECT knob to select "DRC", and then press
SELECT knob to confirm.
2 Turn SELECT knob to select "High", "low" or "off", and then press SELECT
knob to confirm.
Storing an DAB station preset
Your Speaker can store up to 10 DAB radio stations in its preset memories for
instant access to your favourite stations.
1. Tune the Speaker to the DAB radio station that you wish to preset.
2. Press and hold the Preset button for approximately 2 seconds until 'Save
to Preset' is displayed.
3. Turning the select knob to select the Preset location that you would like to
store the radio station to (1-10).
4. Press and release the Select knob. The display will confirm 'Preset X saved' ,