Using The Instrument - Amann Girrbach steamer X3 Instrucciones De Servicio

Ocultar thumbs Ver también para steamer X3:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

O P e r at I n g I n s t r u C t I O n s
sWItChIng On the unIt FrOM COld
In the morning, always fill the boiler before turning
the instrument on.
Important:
gB
If the unit is switched on from cold, the tank should
be ventilated to prevent noises when heating up.
Immediately after switching on the unit activate
the switch
*
for 5 s to ventilate the tank.

usIng the InstruMent

When the green indicator lamp
instrument is ready for use. To perform cleaning
operations, remove the steam head
holder
– being careful not to touch the nozzle
&
(risk of burning). With the steam head in a sink,
turn on the switch located on the steam head
and point the jet of steam towards the object to
be cleaned. When the operation is finished, put
the steam head back onto its holder
indicator light will change from green (ready for
use) to red (heating) for a short period after the
steam cleaning procedure.
MInIMuM Water leVel
When the minimum water level in the boiler has
been reached, the lower orange warning light
will turn on. The heating system will automatically
shut off. Because the boiler is very well insulated,
the vapor flow can be used for a certain amount
12
on the handpiece and keep pressed
turns on, the
#
of time even after the heater has turned off. This
residual vapor can be used for cleaning operations.
When finished, turn off the instrument by means
of the power switch and allow it to cool.
FIllIng the InstruMent
Do not fill the instrument when it is still hot
(risk of burning). See the safety aspects. Always
use cold water to fill the Steamer X3. Once the
instrument has sufficiently cooled, the safety
cap
can be carefully opened.
^
_ Fill Steamer X3 with cold water through the
filler neck. Pour small amounts of water into
the boiler until it is completely full.
_ Close the filler neck by tightly screwing on the
from the
safety cap
*
_ Turn the instrument on by means of the
power switch
*
saFety asPeCts:
. The
WarnIng! rIsk OF InJury!
&
The instrument is under high pressure when
switched on. The safety cap
screw
(
instrument is on and/or hot. Never point the jet
of steam at people or animals – risk of burning.
Make sure that the main power switch
the OFF position and that the instrument has
sufficiently cooled before opening the safety cap
The instrument should no longer be pressurized
%
when opening the safety cap. If the instrument is
still under pressure when the safety cap is
removed, the outcoming steam could cause
.
^
.
!
or the drainage
^
should never be opened when the
is in
!
.
^

Publicidad

Tabla de contenido
loading

Tabla de contenido