SPX Johnson Pump Ultima Switch Manual Del Usuario página 10

> English
2. Do not mount the UltimaSwitch directly to the hull of the
boat. Use a mounting block of at least ¾" thick marine
plywood epoxied to the hull of the boat to fasten the
Ultimaswitch.
3. The bottom of the UltimaSwitch can be mounted higher but
never lower than the base of the pump.
Note: If your mounting the UltimaSwitch on the side of the boat,
make sure you fasten the UltimaSwitch using the side posts
and observing the same mounting instructions as you would
installing the UltimaSwitch in a vertical position.
Mounting:
1. Mark pilot holes in the base of the UltimaSwitch by using the
UltimaSwitch holes.
2. In order to avoid drilling through the hull of the vessel, set
your drill to the appropriate depth for the pilot holes.
3. Fasten the UltimaSwitch directly to the block using #8 x 5/8"
long stainless steel screws (not supplied).
Use these ho-
les for bottom
mounting
10
Use these
holes for side
mounting
Original instructions