Storing The Machine; Disposing Of The Machine; Troubleshooting - BERGIN INOX 190 Manual De Uso Y Mantenimiento

Unsuitable tools are used.
•
IMPORTANT - The customer is responsible for
verifying that original parts only are used when
carrying out repairs. The use of non-original spare
parts could jeopardise the safety of the machine.
When ordering spare parts, specify the model and serial number of
the machine and the reference number of the component in the
spare parts book and quantity.

9 Storing the machine

9.1 Storing the machine
If the machine is not used for long periods, protect exposed parts
(not protected by paint, surface treatment or plastic) with protective
rust prevention oils. If the machine is not to be used for particularly
long periods, you should also clean it thoroughly. After performing
these operations, seal the machine inside an opaque black
multilayer nylon bag together with a suitable drying agent (silica gel).
10 Disposal
10.1

Disposing of the machine

At the end of its working life, the machine must be scrapped and
disposed of by taking it to a local differentiated waste collection
centre in compliance with current legislation which must be followed
scrupulously. Before disposing of the machine, check the machine
rating plate. If it bears the
regulated by EC directive 2002/96 on Waste Electrical and
Electronic Equipment,
information on the local electrical and electronic products collection
system and follow the instructions. Disposing of this product illegally
in the household waste could cause serious damage to the
environment and human health and you may be liable to sanctions
from the local authority.
11 Table of regular maintenance
OPERATION
Check the functioning of all
controls
Check connector gaskets
Check oil level in the pump
symbol, this means its disposal is
WAEE. You should therefore
X
X
X X

12 Troubleshooting

The table below gives the most common problems which
may arise during normal use of the high pressure washer.
These problems are easy to resolve with operations
classified as routine maintenance If the problem is not
present in the following table or cannot be eliminated
following the instructions here, contact customer service.
PROBLEM
The machine does
not start up
Motor does not start
but makes a noise
Inadequate
pressure
Vibrations
abnormal
discharge
seek
Pump noisy
"White" oil
Water leaks
CAUSE REMEDY
Electrical power Check
supply absent or characteristics of the
inadequate power line
Electrical Contact
protection service
tripped
Inadequate Check
voltage characteristics of the
power line
Nozzle blocked Clean or replace
or distorted
Valve dirty or Contact
worn service
and/or The pump is Check water supply
water sucking in air connectors
Air in the hoses Vent
disconnecting
hose
Pump gaskets Contact
worn service
Suction delivery Unscrew valve caps,
valves blocked remove and clean
(ideally
customer service)
Bearings worn Contact
service
Seepage of Have the seal pack
water into the oil replaced
(emulsion) customer service
Gaskets and/or Have the seal pack
pistons worn replaced
customer service
the
customer
the
customer
the air by
the
customer
contact
customer
by
by