KENMORE ELITE 796.6155 Serie Manual De Uso página 22

INSTALLATION INSTRUCTIONS
REVERSING THE TWO-WAY DOOR (continued)
15
Reinstall the side interlock button.
Reinstall the side interlock button removed in step 7.
Center the spring in the compartment and insert the
interlock button on top of it.
16
Reinstall the door cover.
Clean the glass on the door and door cover, if
necessary.
Make sure the two gray interlock buttons are
properly installed and that the top and side lock rods
are properly aligned where they meet. Carefully
lower the door cover into place, aligning the holes in
the cover with the interlock buttons on the top and
side and the bumpers on the bottom. Take care not
to dislodge the lock rods while mounting the door
cover. Once the door cover is in place, secure it with
the 12 screws removed in step 4.
The ten similar screws go around the top and sides
of the door cover. Make sure to install the two
different screws on the bottom edge, in the locations
marked below.
side
interlock
button
17
Install the top right hinge pivot.
Pick up the upper hinge pivot removed earlier and
rotate it 180 degrees. Press in the side interlock
button on the left side and hold it down while
pressing the hinge pivot into the hinge assembly on
the top right side. If the door has been reassembled
correctly, the lock rod slides back easily and locks
the pivot in place. The door is now ready to remount
on the opposite side of the dryer.
INSTALLATION INSTRUCTIONS
interlock
buttons
bumpers
WARNING:
Be sure to support the weight of the door before
installing the hinge screws.
18
Reinstall the door.
While supporting the door, install the four hinge
screws removed in step 2. Test the swing of the door
to make sure the hinges and latch are properly
aligned and that the door opens, closes, and latches
properly in both directions.
Two
large
screws
Two
small
screws
If the door doesn't operate smoothly, remove the
door and then the door cover to check that the lock
rods and interlock buttons are properly mounted and
aligned. The interlock buttons should be oriented
correctly and operating smoothly. The interlock rods
should be in the proper position and should not
overlap at the contact point. (See steps 12-14.)
If the door is damaged, or if the door does not work after
reassembly, contact the call center at 1-800-469-4663.
22