Assembly - Kenmore 148.16156211 Manual De Uso Y Cuidado

UNPACKING
After removing all parts and hardware pack from the top of the shipping box, and when the only part showing is
the grill head, use a ox cutting knife to slice down the sides of the box. Be careful of staples along shipping box
b
edges.
Remove the corner supports from the box and the styrofoam side pieces from the grill head. With the aid of an
assistant, rest grill head on one of the styrofoam side pieces to protect grease tray. Allow grill head to rest on
cardboard until placing grill head on cart in Step 13.
Open grill lid and remove all packaged parts and packing material.
WARNING: Assemble and place the grill on a flat level surface. Compare the parts and hardware with the
list and diagrams. Do not attempt assembly if any part is missing or damaged.
Use the supplied wrench to attach the casters to the bottom panel as shown below. Attach the two
locking casters at the back of the grill. After attaching all casters, turn the bottom panel over.
Bottom Panel
Caster
Attach the door magnets to the holes in the front of the bottom panel with 2 screws each. Do not fully
tighten at this time.
Bottom Panel
Door Magnet
Locking Caster
18
5/32-32 x 3/8"Screw
Qty. 4