Cylinder Cooling Fins; Engine Screen; Spark Arrester - Maruyama BL3200 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cylinder Cooling Fins

Maintenance Interval
The cylinder cooling fins should be cleaned after every 25
hours of operation, or once a week, whichever comes first.
Air must flow freely around and through the cylinder
cooling fins to prevent engine overheating. Leaves, grass,
dirt and debris buildup on the fins will increase the
operating temperature of the engine, which can reduce
engine performance and shorten engine life.
Cooling Fin Cleaning
1.
With the engine at ambient (room) temperature,
loosen the knob and remove the air cleaner cover.
2. Twist the high tension lead boot on the spark plug
back and forth a couple of times to loosen the boot,
then pull the boot off of the spark plug.
3. Remove the four screws retaining the top cover, then
remove the top cover.
4. Clean all dirt and debris from the cooling fins and
from around the cylinder base.
5. Reinstall the top cover and the cleaner cover.

Engine Screen

Maintenance Interval
The screen should be cleaned and inspected each time the
Handheld Blower is used.
Screen Cleaning
Clean all dirt and debris from the screen.

Spark Arrester

Maintenance Interval
 The spark arrester should be inspected and cleaned
after every 25 hours of use.
 Replace the screen if it cannot be thoroughly cleaned,
or if it is damaged.
Spark Arrester Maintenance
1.
With the engine at ambient (room) temperature.
2.
Remove the two screws retaining the muffler.
US- 17 -

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Bl32Bl32-1

Tabla de contenido