Kuppersbusch EEBP6260.0 Manual Del Usuario página 28

INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
My accessories and shelf
supports are damaged.
The enamel colour has
changed and stains have
appeared.
The oven door is locked, pilot
light is lit up but the oven
is not hot.
I have turned the control dial
to position , pressed the
key, I can see the P1, P2
or P3 on the display but the
pilot light is not lit up and
the oven is not heating up.
I have turned the control dial
to position , pressed the
key, I can see the P1, P2
or P3 on the display but the
pilot light is not lit up and
the oven is not heating up.
28
CAUSE
You have not removed the
accessories and supports
during the pyrolytic cleaning
cycle.
The chemical composition of
some foodstuffs may cause
changes in the enamel.
You have turned the control
dial to position
other additional operation has
been performed.
The oven door has not been
closed properly so it cannot
be locked automatically.
The door switch is not working
even though the door is
properly closed.
You must replace them and
remove them in later cleaning
cycles.
This is normal and does not
damage the properties of the
enamel.
Switch off the oven and follow
and no the instructions to unlock the
door in the first 45 minutes at
a low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
Check the door and make
sure that it is closed properly.
Call Technical Assistance
Service as there is a fault in
the door switch.
SOLUTION