Description Of The Machine; General Description; Manufacturing Features - Mastro 40M-50M2 Manual De Instrucciones

supply. Also check that the pilot lamp turns on when the appliance is
functioning .
−
For the model 45K check that the heating plate and the teflon profile heat by
operating on switches 4 e 6 (FIG. n°9). Contemporaneously, make sure that the
pilot lamp (ref. 5 FIG. n°9) turns on together with switch 6 (FIG. n°9). Check
that the temperature of the heating plate increases when you rotate knob 2
(FIG. n°9) .
CHAP. 5 - USE OF THE MACHINE
5.1 - CONTROLS
The controls are placed on the appliance as indicated in the figure below.
40M 51M
1
1
45C 45K
2
5
4
1
2
FIG. n°9 - Controls position
5.2 - FIRST USE OF THE MACHINE
When the machine is delivered, the steel surfaces are protected with a nylon
anti-scratch film. This film has to be removed accurately before starting the
machine and pay attention to remove eventual residuals of glue.
N.B.: To perform this operation, do not use sharpening tools, inflammable or
abrasive substances.
At his stage, it is necessary to start the machine outside, putting it at the
maximum for 15-20 minutes and let it function without product.
Because the insulating materials used during the manufacturing and the residuals
of grease due to the mechanical installation of single parts, heat and produce
smoke.
2
LEGEND:
1. main switch;
2. temperature regulator;
3. pilot lamp indicating the con-
nection to the power supply ;
3
4. heating teflon profile switch;
5. pilot lamp indicating the hea-
6 ting power;
6. heating plate switch.
12
product , or other kind of injuries due to the maintenance operations.

1. 3 - DESCRIPTION OF THE MACHINE

1.3.1 - General description

Our firm has designed and manufactured the DISPENSER to pack foostuffs (as
meat, cheese, pasta, fresh fruit and vegetables, etc.) and to guarantee:
•
the highest degree of safety in functioning, cleaning and maintenance;
•
the highest hygienic standard due to an accurate choice of materials which
come into contact with the foodstuffs;
•
the lowest loss of heat produced by the resistances;
•
solidity and stability of all the elements;
•
great handiness.

1.3.2 - Manufacturing features

The DISPENSERS are available in two different models: with varnished plate or
stainless steel AISI 304. The leaning plate is made of stainless steel AISI 304,
while the thermowelding plate is made of teflon and the electric system cover is a
galvanized plate.
5