Hilti C 4/36 Manual De Instrucciones página 22

6.5.1.1 Using the Company Card to set the
TPS code
1. Check to ensure that no battery is in the
charger.
2. Plug the appliance's supply cord into the
power outlet.
3. Hold the Company Card against the lock
symbol on the appliance within one minute.
The yellow TPS LED blinks rapidly (pro-
gramming mode).
4. Remove the Company Card from the lock
symbol.
5. End the code-setting operation by unplug-
ging the supply cord from the power outlet
and waiting until the green lamp on the
charger goes out.
NOTE This may take several seconds.
6.5.1.2 Using the Company Card to cancel
the code
1. Check to ensure that no battery is in the
charger.
2. Plug the appliance's supply cord into
the power outlet. The yellow lamp blinks
slowly.
3. Hold the Company Card against the lock
symbol on the appliance within one minute
(please refer to the operating instructions
for the appliance for the position of the
lock symbol). The yellow TPS lamp blinks
rapidly.
4. Remove the Company Card from the lock
symbol.
5. Hold the Company Card against the lock
symbol on the appliance again. The yellow
lamp goes out and the theft protection
code is cancelled.
6. End the code-cancelling operation by un-
plugging the supply cord from the power
outlet and waiting until the green lamp on
the charger goes out.
NOTE This may take several seconds.
6.5.2 Activation of the theft protection
system for the battery
6.5.2.1 Using the Company Card to
activate the TPS battery theft
protection system
1. Check to ensure that no battery is in the
charger.
2. Plug the appliance's supply cord into the
power outlet.
3. Hold the Company Card against the lock
symbol on the appliance within one minute.
The yellow TPS lamp blinks rapidly.
4. Remove the Company Card from the lock
symbol.
5. Depending on the type of Hilti battery,
push or slide the battery into the interface
provided. The charging operation doesn't
begin.
6. Press the TPS battery activation button on
the charger. The yellow TPS battery lamp
on the charger lights.
7. Remove the battery from the charger.
8. Repeat steps 5 to 7 according to the num-
ber of batteries in which the code is to be
set.
9. End the code-setting operation by unplug-
ging the supply cord from the power outlet
and waiting until the green LED on the
charger goes out.
NOTE This may take several seconds.
10. The batteries can now be charged as usual
in any Hilti charger for Li-ion batteries with
TPS and the corresponding code.
6.5.2.2 Using the Company Card to cancel
the TPS theft protection code in
the battery
1. Check to ensure that no battery is in the
charger.
2. Plug the appliance's supply cord into the
power outlet.
3. Hold the Company Card against the lock
symbol on the appliance within one minute.
The yellow TPS lamp blinks rapidly.
4. Remove the Company Card from the lock
symbol.
5. Depending on the type of Hilti battery,
push or slide the battery into the interface
provided. The charging operation doesn't
begin. The yellow TPS battery lamp lights.
6. Press the TPS battery activation button on
the charger. The yellow TPS battery lamp
on the charger goes out.
7. Remove the battery from the charger.
8. Repeat steps 5 to 7 according to the num-
ber of batteries in which the code is to be
cancelled.
en
19